prototype test
英 [ˈprəʊtətaɪp test]
美 [ˈproʊtətaɪp test]
原型测试，样机试验
双语例句
- It was first proposed the way to predict all the parameters in the Weibull distribution without prototype test.
首次提出并论证了不进行现场实测和调查统计就可确定出韦布尔分布中各参数的方法。 - A corresponding analytical system named TDGS was proved to be quite effective in simulating a prototype test specimen.
相关的TDGS分析系统针对原型试验取得了较好的模拟效果。 - Based on the analysis to signal detection theory of FOG, the analog demodulation circuit and digital logic circuit etc were designed, and prototype test was carried out.
在对光纤陀螺信号检测理论分析的基础上，设计了模拟解调电路、数字逻辑电路等，并进行了样机测试。 - The results of prototype test indicated that the instrument solved the problem of convenient use and measuring precision for fuel consumption measuring on one-hundred-kilometer.
样机试验表明该仪器较好地解决了百公里油耗测量中使用方便性及精度等问题。 - Develop prototype test results show that the system meets the requirment of technical specifications.
原理样机的试验结果表明本设计能够达到所要求的技术指标。 - The α star in the canis major is used as target star. The correctness and feasibility of the calibration method has been validated by the ground prototype test system.
以大犬星座α星为目标星，利用地面原型试验系统对校准方法的正确性及可行性进行了验证。 - Experiments show that the patent is correct and practical through prototype test. It will be widely applied to large waterpower and wind power generators.
通过原型样机的试验，验证了该项发明的正确性和实用性，它将在大型水电、风电中得到广泛应用。 - By means of the discussion of the results of the prototype test, the methods of further improvement of system performance and the prospects of application were revealed.
通过对控制器样机实验结果的讨论，指出了进一步提高系统性能的方法及应用前景。 - The prototype test verifies the separation efficiency of the new separator.
针对试制的样机，通过室内模拟试验，验证了井下水力旋流油水分离器的分离效率。 - At present, four methods are mainly used for reinforcement earth research: prototype test, model test, three-axial compression test, direct shear test and drawing test.
目前加筋土的试验研究主要有四种方法：原型试验、模型试验、三轴压缩试验、直剪试验和拉拔试验。 - It introduced the testing process of Manufacturing Resource Plan MRP I Prototype, and discussed the solutions for solving the problems occured during the prototype test and the problems occured during the software lectotype by the enterprises when they carry out MPR I project.
介绍了制造资源计划MRPⅡ原型测试过程，讨论了在进行原型测试过程中对遇到的若干问题的解决办法，以及在企业实施MRPⅡ工程中经常遇到的软件选型问题。 - Finally, the flow of cooperative map-editing was discussed based on CORBA and database technology. The prototype test system was developed.
最后，借助于CORBA分布式计算技术和数据库技术，构建了基于上述模型的协同GIS原型系统，给出了系统的测试情况； - A Research on to Prototype Test
对原型试验的探讨 - Research on MRP I Software Lectotype Based on the Prototype Test
基于原型测试的MRPⅡ软件选型研究 - Calculation and prototype test are conducted on improved heat dissipating system, the result showed that the improved system met the requirements of design.
对改进后的液压散热系统进行计算和实车试验，结果表明改进后的系统符合设计要求。 - ADAMS/ CAR software, the virtual steady circular tests were performed and validated with the physical prototype test results.
ADAMS/CAR软件，建立了该车的虚拟样车模型，对稳态回转特性进行了虚拟样车试验及验证。 - Only dynamic prototype test was conducted on one dam. On the other one, prototype and model test and analysis were performed.
对一座进行了原型振动试验，对另一座完成了原型与模型的振动试验以及动力有限元分析。 - Based on the field test of the pump unit, this paper studies the prototype test method and the performance characteristics of this kind of pump.
通过对大泵机组综合特性的现场试验研究，探讨了大型水泵机组现场测试方法，研究了双速全调节轴流泵机组的运行特性。 - The results fully correspond with the theoretical calculations in the experimental prototype test.
对试验样机进行了测试，其结果与理论计算完全相符。 - Through continuous debugging, comparison, ultimately identified with the prototype test data closer to the simulation model, provided a computer simulation platform for the traction characteristics study, saved a lot of time to repeat the test.
通过不断调试、对比，最终确定了与试验数据较接近的仿真模型。为国内液力机械式履带推土机牵引特性分析提供了一个计算机仿真平台，节省了大量重复试验的时间。 - At the same time, the complexity of the bracing system leads to the prototype test analysis considerable difficult.
同时，由于支护体系和土体的复杂性，对其进行完整的现场原型试验分析也有相当大的困难。 - Then it is embedded into the Advisor vehicle simulation model. Finally, conduct a simulation according to the established Advisor vehicle simulation model and conduct prototype testing, research and analysis through the simulation results and prototype test results.
最后嵌入到Advisor整车仿真模型。四、根据所建立的Advisor整车模型进行仿真，并进行样车试验，对仿真结果与样车试验结果进行研究分析。 - In addition, we analysis the relevance of this objective and subjective score by doing many experiments and give the experimental results. Finally, we design a prototype test system according to the research work and content above.
最后，针对上述研究工作和内容，设计实现了一个原型实验测试系统。 - Experiments show that, the system prototype test result basically achieved the indicators.
实验表明，系统的原理样机的实验结果基本达到了预期指标。 - On this basis, designs the structure of the system. The test system developed can automatically achieve prototype test and delivery test.
在此基础上，对检测系统的软、硬件进行设计，研制出了能够自动完成液压缸型式试验和出厂试验的检测系统。 - Finally, the prototype test, the validity of the instrument is verified, that the program is reasonably practicable and reliable design.
最后通过样机试验，对仪器的有效性进行了验证，表明该方案合理可行，设计可靠。 - A brief introduction to the physical prototype test ride the two test methods: Methods and road test bench method, and by the idea of bench introduced a simplified method of military off-road vehicle "suspension-tires-road," composed of vibration system.
简单介绍了实物样机平顺性试验的两种试验方法：道路试验方法和台架试验方法，并通过台架试验方法的思路引入一个简化的军用越野汽车悬架一轮胎一路面组成的振动系统。 - The main task of this thesis is to develop a comprehensive control test device on gasoline direct injection engine to meet the needs of a national 973 projectSI/ HCCI prototype test and visualization test.
国家973计划项目SI/HCCI原理性样机试验和可视化试验研究中，需要实现缸内直喷的灵活控制，所以，本课题的任务是完成缸内直喷汽油机综合控制试验装置的开发。 - Application design and virtual prototype test.
应用实例设计及虚拟样机试验。